Charger SRT-8 V8-6.1L (2009)
5. Swing spring link up to bushing in crossmember and install bolt and nut (1) fastening spring link (4) to crossmember. Do not tighten bolt at this
time.
6. Export Only - If servicing right side bushing, connect headlamp leveling sensor (1) link at spring link (3).
7. Install rear spring as well as all components necessary to access it. See: Suspension Spring ( Coil / Leaf )/Service and Repair/Rear Suspension -
Coil Spring(s) - Installation
8. Lower vehicle.
9. Position vehicle on alignment rack/drive-on lift. Raise vehicle as necessary to access mounting bolt.
10. Tighten spring link bolt (1) at crossmember to 108 Nm (80 ft. lbs.).
11. Perform wheel alignment. See: Alignment/Service and Repair