Charger SRT-8 V8-6.1L (2009)
6. Position under-hoist utility jack or transmission jack (3) under center of rear axle differential (1). Raise jack head to contact differential and secure
in place.
7. Remove shock absorber (1) lower mounting bolt (2) and nut (4).
CAUTION: When removing crossmember mounting bolts (2 and 3) it is important NOT to loosen or remove crossmember mounting bolts on
opposite side of vehicle. Doing so will require rear wheel alignment following reinstallation to ensure proper thrust angle.
8. Remove both front and rear crossmember mounting bolts (2 and 3) on repair-side of vehicle. If equipped with AWD, be sure to not to misplace
spacers between crossmember mounts and body.
