Charger SRT-8 V8-6.1L (2009)
2. On both sides of vehicle, remove wheel mounting nuts (3), then rear tire and wheel assembly (1).
WARNING: Before opening fuel system, review all Warnings and Cautions.
3. If servicing left side shock absorber, remove fuel filler tube. See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Fuel Filler
Neck/Service and Repair/Removal
4. Position an extra pair of jack stands under and support forward end of engine cradle to help stabilize vehicle during rear suspension
removal/installation.
5. Perform following if vehicle is equipped with dual-exhaust or are servicing right side on vehicle with single exhaust.
a. Position under-hoist utility jack or stand several inches below exhaust at muffler.
b. Disconnect exhaust isolators at muffler and resonators hangers.
c. Lower exhaust down to rest upon top of jack or stand placed below muffler.
6. Position under-hoist utility jack or transmission jack (3) under center of rear axle differential (1). Raise jack head to contact differential and secure
in place. When securing crossmember to jack, be sure not to secure stabilizer bar.
