Charger SRT-8 V8-6.1L (2009)
NOTE: Inspect disc brake pads and parking brake shoes before brake rotor installation. See: Brakes and Traction Control/Disc Brake
System/Brake Pad/Service and Repair/Procedures/Brake Pads - Inspection
4. Clean hub face (1) to remove any dirt or corrosion where rotor mounts.
5. Install brake rotor (2) over studs on hub and bearing (1).
6. Slide caliper with pads (2) over brake rotor and align with knuckle.
7. Install caliper mounting bolts (1). Tighten bolts to 130 Nm (96 ft. lbs.) torque.
8. Remove jack from under spring link.
NOTE: Always install a new hub nut. The original hub nut is one-time use only and should be discarded when removed.
