Charger SRT-8 V8-6.1L (2009)
CAUTION: Propeller shaft installation is a two-man operation. Never allow propeller shaft to hang from the center bearing, or while only
connected to the transmission or rear axle flanges. A helper is required. If a propeller shaft section is hung unsupported, damage
may occur to the shaft, coupler, and/or center bearing from over-angulation. This may result in driveline vibrations and/or
component failure.
COUPLER/DAMPER SERVICE
1. If coupler and/or damper (V6 Models) were removed, align index marks and reinstall. Make sure protruding sleeve (2) is properly seated into
propshaft or damper counterbores.
2. Install three bolts with washers and nuts and torque to 58 Nm (43 ft. lbs.) torque.
3. Obtain helper and install propeller shaft into position at axle. Align index marks placed upon removal. Install propeller shaft rear coupler-to-axle
flange bolt/nuts by hand. Do not torque at this time.
