Charger SRT-8 V8-6.1L (2009)
Rear Door Window Regulator: Service and Repair
Rear Door Window Regulator - Removal
REMOVAL
1. Remove the trim panel from the inside of the rear door. See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Rear Door Panel/Service
and Repair/Rear Door Trim Panel - Removal.
2. Remove the watershield from the inside of the rear door. See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Rear Door Panel/Service
and Repair/Watershield - Removal.
3. Remove the door glass channel and bracket from the inside of the rear door. See: Window Track/Service and Repair/Rear Door Glass Channel -
Removal.
4. Remove the screw (2) that secures the bottom of the pull cup bracket (1) to the inside of the rear door.
5. Loosen the screw that secures the top of the pull cup bracket to the inside of the rear door.
6. Disengage the upper pull cup bracket screw from the keyed hole and remove the bracket from the inside of the rear door.
7. Using the regulator, adjust the rear door glass (1) position up or down as required for access to the two window regulator glass clamps (2).
8. Loosen the screw (3) in each of the glass clamps far enough to release the glass.
9. Lift the glass out of the regulator clamps and into its full up position, then tape the glass securely into place.
