Charger SRT-8 V8-6.1L VIN W (2006)
Front Door Panel: Removal and Replacement
WATERSHIELD
REMOVAL
CAUTION: Do not allow the watershield or adhesive to become contaminated with dirt or other foreign substances.
Do not damage the watershield during removal and installation.
If the watershield becomes contaminated or damaged, replace the watershield.
1. Remove the trim panel from the inside of the front door.
2. Carefully separate the lower half of the watershield (2) from the inside of the door (1).
3. Lift the lower half of the watershield upward far enough to access and pull the trim panel take outs of the door wire harness out of the slit near the
center of the watershield.
4. Carefully separate the upper half of the watershield from the inside of the door.
5. Lift the upper half of the watershield upward far enough to disengage the inside latch lock knob and link and the inside remote latch release handle
link from the slit near the upper rear corner of the watershield.
6. Remove the watershield from the door.
INSTALLATION
CAUTION: Do not allow the watershield or adhesive to become contaminated with dirt or other foreign substances.
Do not damage the watershield during removal and installation.
If the watershield becomes contaminated or damaged, replace the watershield.