Charger SRT-8 V8-6.1L VIN W (2006)
INSTALLATION
1. Ensure the seat adjuster (2) is in the full up position by pulling upward on the upper adjuster assembly.
2. Position motor (3) on seat adjuster (2).
3. Install the motor shaft screw and washer and tighten until snug. Do not torque screw at this time.
4. Install the screws (1) holding the motor (3) to the seat adjuster (2). It may be necessary to twist the motor slightly to align the fastener holes.
5. Starting with the bottom screw, tighten the motor screws (1) to 9 N.m (80 in. lbs.).
6. Tighten the motor shaft screw and washer to 6.5 N.m (57.5 in. lbs.).