Charger SRT-8 V8-6.1L VIN W (2006)
Battery Tray: Service and Repair
Battery Holddown
BATTERY HOLDDOWN
REMOVAL
1. Verify that the ignition switch and all accessories are OFF.
2. Remove the rear compartment floor, trim panel to gain access to the battery.
3. Disconnect and isolate the battery negative cable.
4. Remove the bolt from the battery hold down and remove the hold down.
INSTALLATION
1. Install the battery hold down clamp and bolt. Torque the bolt to 4 N.m (35 in. lbs.).
2. Connect the battery negative cable.
3. Install the rear compartment floor trim panel.