Charger SRT-8 V8-6.1L VIN W (2006)
NOTE: If the original urethane adhesive has been exposed for more than 12 hours, the entire adhesive area will need to be re-primed prior to
installing new adhesive.
17. Apply approximately a 10 mm (0.4 in.) wide bead of adhesive (1) with a triangular nozzle approximately 6 mm (0.230 in.) from the edge of the
glass (2) starting at the bottom center of the backlite.
18. Run the end of the adhesive bead (1) on the backlite (2) parallel to the start of the bead and smooth the ends flush.
19. Using an assistant, position the backlite (2) over the backlite opening.
20. Using the grease pencil marks or tape as reference points, align the backlite to the opening.
21. Carefully lower the backlite onto the backlite fence (3). Guide the backlite and the rubber seal (1) around the backlite into its proper location.
CAUTION: It is not possible to move the backlite after installation. The backlite should never be pressed into place by more than one
person, because the backlite can break if pressed simultaneously on both sides.
22. Push the backlite inward until the backlite comes into contact with the spacers located on each side of the backlite fence.
23. Connect the wire connectors to the rear window defogger terminals and, rear window mounted radio antenna, if equipped.
24. Install the trim panel to the rear shelf.
25. Install the quarter trim panels.