dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3601 > < Initial Inspection and Diagnostic Overview|Page 3599
Page 1
background image

Engine Control Module: Component Tests and General Diagnostics

Engine Control Module Power Ground

ECM Harness Inspection

TROUBLESHOOTING HINTS

If the ground wire of the engine control module is not connected securely to ground, the module will not operate correctly.

Idle Learn Procedure, Battery/Power Disconnect

1. Prior to connecting or disconnecting the negative battery cable, turn ignition switch and light switch off. Failure to do so may result in damage to

semiconductor parts.

2. After reconnecting negative battery terminal start and warm engine. Allow engine to idle for approximately 5 minutes under the following

conditions.

Engine coolant temperature 185 - 203°F (85 - 95°C)
Lights, electric fans, accessories OFF
Transaxle neutral
Steering wheel in center position

Initial Inspection and Diagnostic Overview|Page 3601 > < Initial Inspection and Diagnostic Overview|Page 3599