D250 3/4 Ton Pickup 2WD V8-318 5.2L VIN Y FI (1988)
Turn Signal Switch: Service and Repair
Turn Signal/Hazard Warning Switch
1.
Disconnect battery ground cable.
2.
Remove lower bezel from instrument panel.
3.
Remove horn sounder and steering wheel. Refer to Steering and Suspension/Steering/Steering Wheel/Service and Repair.
4.
On models w/standard columns proceed as follows:
Turn signal switch retainer removal. Standard columns
a.
Remove turn signal lever to switch attaching screw, then the lever. If equipped with speed control, allow lever to hang free.
b.
Remove switch retainer attaching screws, then the retainer.
5.
On models w/tilt columns, proceed as follows:
a.
Remove plastic cover from lock plate, if equipped.
Lock plate retaining ring removal
b.
Depress lock plate using tool C-4156 or equivalent, then pry retaining ring out of groove using screwdriver. The full load of the cancelling
cam spring should not be relieved. If full load is relieved, retaining ring will turn too easily, making removal more difficult.
c.
Remove lock plate, cancelling cam and spring, then place turn signal lever in right turn position.
d.
Remove turn signal lever to switch attaching screw, then the lever. If equipped with speed control, allow lever to hang free.
Turn signal switch removal. Tilt columns
