D50/Power Ram 50 L4-2350cc 2.4L SOHC (1992)
Blower Motor: Service and Repair
Fig. 4 Heater & Blower Housing Assemblies
1.
Disconnect battery ground cable.
2. Remove glove box stopper and frame.
3. Disconnect air select control cable, then remove duct between blower and heater housings.
4. Remove blower attaching screws, blower assembly and gasket.
5. Reverse procedure to install. Place air select control in fresh air position, and move lever on intake housing against stop, then connect cable to
lever and secure cable housing with clip.
