D50/Power Ram 50 L4-2555cc 2.6L SOHC (1987)
Alignment: Service and Repair
Camber
FRONT
Fig. 3 Caster & camber adjusting shim selection chart. 1987-88 Ram 50
Caster and camber are adjusted together by adding or removing shims from between the upper control arm shaft and crossmember.
1. Check alignment angles following equipment manufacturer's instructions.
2. If caster and/or camber are not within specifications, loosen nuts securing upper control arm shaft to crossmember.
3. Increase or decrease thickness of shims between control arm shaft and crossmember, noting the following:
a. Refer to chart, to select proper shims.
b. Do not use more than 4 shims at one location.
c. Difference in shim thickness between front and rear bolts must not exceed 0.16 inch (4 mm).
REAR
Rear camber is pre-set during vehicle assembly and cannot be adjusted. If camber is not within specifications, check for worn or damaged suspension
component, and damaged or deformed floor pan or body and repair as needed.
