dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Radio - Short Circuit Diagnostic Feature|Page 4045 > < Radio - Short Circuit Diagnostic Feature|Page 4040
Page 1
background image

Speaker: Technical Service Bulletins
Radio - Short Circuit Diagnostic Feature

NO.: 08-17-91

GROUP:

ELECTRICAL

DATE:

Dec. 2, 1991

SUBJECT:

Radio Speakers Inoperative

MODELS:

1992

(AA) ACCLAIM/SPIRIT/LEBARON SEDAN
(AB) RAM VAN/WAGON (RWD)
(AC) DYNASTY/NEW YORKER SALON
(AD) RAM PICKUP/RAM CAB & CHASSIS/RAMCHARGER
(AG) DAYTONA
(AJ) LEBARON COUPE/LEBARON CONVERTIBLE
(AN) DAKOTA PICKUP
(AP) SUNDANCE/SHADOW/SHADOW CONVERTIBLE
(AS) CARAVAN/GRAND CARAVAN/CARAVAN C/V

VOYAGER/GRAND VOYAGER/TOWN & COUNTRY

(AY) IMPERIAL/NEW YORKER FIFTH AVENUE

DISCUSSION

For the 1992 model year, Huntsville radios, sales codes RAL, RAS, and RAN, will incorporate a short circuit detection feature. This new diagnostic
feature will aid in identifying and locating a short circuit in the vehicles speaker wiring. This feature is included in all 1992 RAL and RAS radios. On
vehicles equipped with RAN radios, this feature is included if the vehicle is built after MDH 11-18-XX.

RAL and RAS radios have knobs to tune the radio and adjust volume. RAN radios, both Infinity and non-Infinity, have toggle switches to tune the radio
and adjust volume, and a joystick for adjusting balance and fade.

DIAGNOSIS OF RAL AND RAS RADIOS:

1. Turn the radio on and set the volume to a comfortable listening level.

2. If the radio display does not operate, refer to the appropriate service manual for audio system diagnosis. If the radio display does operate, continue

with this procedure.

3. Turn the balance and fade controls to their middle positions. If no sound is heard, there may be a speaker wiring short.

4. Move the balance and fade controls to the left front, right front, left rear, and right rear. If sound is heard from any speaker while the balance and

fade controls are in these positions there is a short in one of the speaker feed wires.

If the front speakers have normal sound, and one of the rear speakers has low sound, and the other rear speaker has no sound, the rear speaker with low
sound has a short in one of the speaker feed wires.

Inspect the wires from the black radio connector pins 5 and 6 for a short to ground.

If the rear speakers have normal sound, and one of the front speakers has low sound, and the other front speaker has no sound, the front speaker with low
sound has a short in one of the speaker feed wires.

Inspect the wires from the black radio connector pins 3 and 4 for a short to ground.

5. If no sound is heard at any point in the above adjustment to the balance and fade controls a short may still be present. Inspect the wires from the gray

radio connector pins 5 and 6 and from the black radio connector pins 1 and 2 for a short to ground.

6. If the above test detects no problem, replace the radio.

DIAGNOSIS OF RAN RADIOS:

1. Turn the radio on and set the volume to a comfortable listening level.

Radio - Short Circuit Diagnostic Feature|Page 4045 > < Radio - Short Circuit Diagnostic Feature|Page 4040