D 150 Pickup V8-360 5.9L VIN W (1987)
FIGURE 7
C.
^ With a piece of tape, mark the shank end of a 3/16" drill bit a distance of 1-1/4" from the end. Remove the carburetor fuel inlet hose and
insert the fuel inlet orifice, PN 4418021, with the drill bit to a depth of 1-1/4". Reinstall the fuel inlet hose (Figure 7).
^
Cut two pieces of 3/16" diameter vacuum hose (serviced in bulk PN 4105167) into the following lengths, 2" and 32".
FIGURE 8
^
Make an overlay harness using the two pieces of cut vacuum hose, the vacuum bleed-off valve, vacuum delay valve, and the vacuum
tee (Figure 8).