Dakota 2WD L4-2.5L VIN P (2001)
7. Remove the insulator assembly (Fig. 64) (Fig. 65).
INSTALLATION
The front mounts support the engine at each side. These supports are made of resilient rubber.
1. Position insulator assembly on cylinder block and install the nuts and bolts. Tighten the bolts to 81 Nm (60 ft. lbs.) torque. Tighten the nuts to 47
Nm (35 ft. lbs.)
2. Install the through bolt and retaining nut but DO NOT TIGHTEN.
3. Lower engine until through bolt and nut are resting in frame bracket and weight of engine is off of supporting device.
4. Tighten the through bolt nut to 68 Nm (60 ft. lbs.) torque.
5. Remove the engine support.
6. Lower the vehicle.
7. Connect negative cable to battery.