Dakota 2WD L4-2.5L VIN P (2001)
Idle Air Control (IAC) Motor: Service and Repair
Fig. 25 Mounting Bolts(Screws) - IAC Motor
The IAC motor is located on the side of the throttle body.
REMOVAL
1. Remove air duct at throttle body.
2. Disconnect electrical connector from IAC motor.
3. Remove two mounting bolts (screws).
4. Remove IAC motor from throttle body.
INSTALLATION
1. Install IAC motor to throttle body.
2. Install and tighten two mounting bolts (screws) to 7 Nm (60 in. lbs.) torque.
3. Install electrical connector.
4. Install air duct at throttle body.