Dakota 2WD L4-2.5L VIN P (2001)
Crankshaft Position Sensor: Description and Operation
The Crankshaft Position (CKP) sensor is located near the outer edge of the flywheel (or starter ringear).
Engine speed and crankshaft position are provided through the CKP sensor. The sensor generates pulses that are the input sent to the Powertrain Control
Module (PCM). The PCM interprets the sensor input to determine the crankshaft position. The PCM then uses this position, along with other inputs, to
determine injector sequence and ignition timing.
The sensor is a hall effect device combined with an internal magnet. It is also sensitive to steel within a certain distance from it.
Fig. 25 CKP Sensor Operation
The flywheel/drive plate has groups of four notches at its outer edge. On This engine there are two sets of notches.
The notches cause a pulse to be generated when they pass under the sensor. The pulses are the input to the PCM. For each engine revolution there are
two groups of four pulses generated on this engine.
The trailing edge of the fourth notch, which causes the pulse, is four degrees before top dead center (TDC) of the corresponding piston. The engine will
not operate if the PCM does not receive a CKP sensor input.
