Dakota 2WD L4-2.5L VIN P (2001)
10. Gauge should read below 862 kPa (125 psi), if above, inspect the hoses for restrictions and repair as necessary. The initial pressure reading should
be in the range of 345 - 552 kPa (50 - 80 psi).
11. Increase the engine speed to 1500 RPM and read the flow meter. If the flow rate (GPM) is below specification, the pump should be replaced.
CAUTION: The following test procedure involves testing maximum pump pressure output and flow control valve operation. Do not leave valve
closed for more than three seconds as the pump could be damaged.
12. Close valve fully three times and record highest pressure indicated each time. All three readings must be above specifications and within 345 kPa
(60 psi) of each other.
-
Pressures above specifications but not within 345 kPa (50 psi) of each other, replace pump.
-
Pressures within 345 kPa (50 psi) of each other but below specifications, replace pump.
13. Open the test valve and turn the steering wheel to the extreme left and right positions three times against the stops. Record the highest pressure
reading at each position. Compare readings to the pump specifications chart. If pressures readings are not within 50 psi of each other, the gear is
leaking internally and must be replaced.
CAUTION: Do not force the pump to operate against the stops for more than 2 to 3 seconds at a time because, pump damage will result.
