Dakota 2WD L4-2.5L VIN P (2001)
1. Thread the inner tie rod end into the rack and pinion.
2. Tighten the inner tie to 68 Nm (50 ft. lbs.).
3. Install the out tie rod end.
4. Install the tire and wheel assembly.
5. Remove the support and lower the vehicle.
6. Set wheel toe pattern.
INSTALLATION - OUTER TIE ROD END
NOTE: Do not twist the boot at anytime during removal or installation.
1. Thread the outer tie rod end onto the inner tie rod, to it's original position.
2. Install the outer tie rod end into the steering knuckle.
3. Tighten the ball stud nut on the steering knuckle to 55 Nm (65 ft. lbs.).
4. Tighten jam nut to 75 Nm (55 ft. lbs.).
5. Set wheel toe pattern.