Dakota 2WD V6-239 3.9L Magnum (1996)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Rear Antilock Valve Replacement
1. Disconnect and remove battery to access valve lines.
2. Disconnect line to rear brakes at rear anti-lock valve.
3. Disconnect line to front brake anti-lock valve at combination valve.
4. Disconnect wire harness and ground wire at anti-lock and combination valves.
5. Remove combination valve retaining nuts.
6. Disconnect anti-lock valve to master cylinder lines.
7. Remove combination valve from master cylinder.
Fig. 101 Rear Anti-Lock & Combination Valve Removal
8. Remove rear anti-lock valve, combination valve, bracket and lines as an assembly.
9. Remove line that connects anti-lock valve to combination valve.
10. Remove anti-lock valve from combination valve bracket.
11. If combination valve is to be replaced, remove connecting lines from valve.
12. Reverse procedure to install, noting the following:
a. Install lines on valve, but do not tighten at this time.
b. Install anti-lock valve on combination valve and install connecting lines. Do not tighten at this time.
c. Install valve and bracket assembly on master cylinder and torque nuts to 16-21 ft. lbs.
d. Install brake lines to master cylinder and torque fittings to 9-14 ft. lbs., then torque all remaining fittings to 12-16 ft. lbs.
e. Bleed brakes as described under Antilock Brake System/Service and Repair and check for leaks.
