Dakota 2WD V6-239 3.9L Magnum (1996)
1. Disconnect and isolate the battery negative cable. If the airbag module is undeployed, wait two minutes for the system capacitor to discharge
before further service.
2. Pull the air cleaner fresh air inlet tube off of the radiator support.
3. Unplug the connector from the right impact sensor.
4. Remove the three nuts holding the right sensor to the closure panel support and remove the sensor.
5. To install, mount the sensor (arrow pointed forward) using the three nuts provided with the new sensor. Tighten the nuts to 3 - 4 Nm (24 - 36 in
lb).
6. Connect the right sensor wiring to the connector on the body of the sensor.
7. Install the air cleaner inlet tube to the radiator support.
8. Do not connect the battery negative cable at this time. See Airbag System Arming for proper procedure. See: Air Bag Systems/Air Bag(s) Arming
and Disarming/Service and Repair
