Dakota 2WD V6-3.7L (2009)
1. Install prop rod on the brake pedal to keep pressure on the brake system, Holding pedal in this position will isolate master cylinder from hydraulic
brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open. This will allow you to bleed out the
area of repair instead of the entire system.
2. Raise and support the vehicle.
3. Remove the brake lines (1AND3) going into the brake hose (2).
4. Remove the brake line (2) from the brake hose (3).
5. Remove the mounting clip (1) for the brake hose (3) at the frame.
6. Remove the hose (3).
Front Brake Hose
FRONT CALIPER HOSE
1. Install prop rod on the brake pedal to keep pressure on the brake system, Holding pedal in this position will isolate master cylinder from hydraulic
brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open. This will allow you to bleed out the
area of repair instead of the entire system.
2. Raise and support vehicle.