Dakota 2WD V8-4.7L (2008)
NOTE: Headliner for Quad Cab model shown. Club Cab similar.
CAUTION: Be careful not to crease the headliner.
1. Position the headliner (6) in the vehicle through the door opening from which it was removed.
2. Connect the headliner wire harness connector (1) to the center high mounted stop lamp.
3. Raise the rear of the headliner (7) to the roof panel and install the two coat hooks, See: Trim Panel/Service and Repair/Coat Hook - Installation.
4. Raise the front of the headliner to the roof panel and install the sun visor supports (3), See: Sun Visor/Service and Repair/Sun Visor Support -
Installation.
5. Connect the wire harness connector (5) located at the right A-pillar.
6. If equipped, connect the headliner wire harness connector (2) to the inside rear view mirror.
7. If equipped, install the overhead console, See: Console/Service and Repair/Overhead Console - Installation.
8. Install the sun visors (4), See: Sun Visor/Service and Repair/Sun Visor - Installation.
9. If equipped, install the front dome lamp, See: Lighting and Horns/Dome Lamp/Service and Repair/Dome Lamp - Installation.
10. Install the A-pillar trim panels, See: Trim Panel/Service and Repair/Pillar Trim/A-Pillar Trim Panel-Installation.
11. If equipped, install the rear dome lamp, See: Lighting and Horns/Dome Lamp/Service and Repair/Dome Lamp - Installation.
12. Install the rear jumper seat headrest sleeves in the headliner.
13. Install the rear jumper seat headrests.
14. Install the cab back trim panel, See: Trim Panel/Service and Repair/Cab Back Trim Panel - Installation.