Dakota 2WD V8-4.7L (2008)
NOTE: Take precautions to locate the master cylinder plunger over the booster output rod, before installing the master cylinder. If
correctly fitted the master cylinder should slide easily onto the booster output rod before the mounting studs are engaged in the flange
holes of the master cylinder.
2. Install new mounting nuts (5) and tighten to 10 Nm (90 in. lbs.)
3. Install the brake lines (3) and tighten to 19 Nm (170 in. lbs.).
4. Reconnect the electrical connector for the low fluid level switch.
5. Fill and bleed the base brake system. See: Brake Bleeding.
