Dakota 2WD V8-4.7L (2008)
The two lower anchors (1) for the passenger side rear outboard seating position of club cab vehicles are integral to a mounting bracket that is secured to
the cab back panel and the rear floor panel with screws. They are each accessed from the front of the seat, at each side where the seat back (2) meets the
seat cushion (3). These lower anchors and their bracket are available for individual service replacement.
The lower anchors (2) for the rear seat of quad cab vehicles are also integral to their respective seat cushion frame. These anchors are also constructed
from a heavy-gauge steel wire loop that is securely welded to the seat cushion frame. They are each accessed from the front of their respective seats, at
each side where the seat back (1) meets the seat cushion (3). These lower anchors cannot be adjusted or repaired and, if ineffective or damaged, they
must be replaced as a unit with the second row seat cushion frame unit.
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.