Dakota 2WD V8-4.7L (2008)
Starter Motor: Service and Repair
Starter Motor - Removal
REMOVAL
3.7L / 4.7L With Manual Trans.
1. Disconnect and isolate negative battery cable.
2. Raise and support vehicle.
3. Note: If equipped with 4WD and certain transmissions, a support bracket is used between front axle and side of transmission. Remove 2 support
bracket bolts at transmission. Pry support bracket slightly to gain access to lower starter mounting bolt.
4. Remove one bolt (9) and one nut (8) if equipped with a manual transmission.
5. Move starter motor (5) towards front of vehicle far enough for nose of starter pinion housing to clear housing. Always support starter motor during
this process, do not let starter motor hang from wire harness.
6. Tilt nose downwards and lower starter motor far enough to access and remove nut (2) that secures battery positive cable wire harness connector
eyelet to solenoid battery terminal stud. Do not let starter motor hang from wire harness.
7. Remove battery positive cable wire harness connector eyelet (1) from solenoid battery terminal stud.
8. Disconnect battery positive cable wire harness connector (7) from solenoid terminal connector receptacle.
9. Remove starter motor.
3.7L / 4.7L With Auto. Trans.
1. Disconnect and isolate negative battery cable.
2. Raise and support vehicle.
3. Note: If equipped with 4WD and certain transmissions, a support bracket is used between front axle and side of transmission. Remove 2 support
bracket bolts at transmission. Pry support bracket slightly to gain access to lower starter mounting bolt.
4. Remove two bolts (3) if equipped with an automatic transmission.
5. Move starter motor (4) towards front of vehicle far enough for nose of starter pinion housing to clear housing. Always support starter motor during
this process, do not let starter motor hang from wire harness.
6. Tilt nose downwards and lower starter motor far enough to access and remove nut (2) that secures battery positive cable wire harness connector
eyelet (1) to solenoid battery terminal stud. Do not let starter motor hang from wire harness.
7. Remove battery positive cable wire harness connector eyelet (5) from solenoid battery terminal stud.
8. Disconnect battery positive cable wire harness connector from solenoid terminal connector receptacle.
9. Remove starter motor.