Dakota 2WD V8-4.7L (2008)
8. Remove the manual window crank and install the watershield. See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Rear Door
Panel/Service and Repair/Door - Rear (Quad Cab)/Rear Door Watershield/Installation
Power
INSTALLATION
1. Place the regulator into the door and engage the bolts (2) into the keyhole slots in the door.
2. Install the one bolt at the motor and the two lower bolts (4).
3. Tighten all the regulator bolts to 9.5 Nm (85 in. lbs.).
4. Connect the electrical connector (3).
5. Remove the tape used to secure the glass during removal and position the glass (1) into the glass clamps.
6. Temporarily install the window switch and raise the glass into the full up position.
7. Tighten the glass clamp screws (2) securely.
