Dakota 2WD V8-4.7L Flex Fuel (2009)
Remote Switch: Service and Repair
Remote Radio Switches - Installation
INSTALLATION
1. Position the remote radio switch (2) to the mounting hole on the outside of the steering wheel rear trim cover. Be certain that the connector
receptacle is oriented toward the bottom of the switch and pointed toward the center of the steering wheel.
2. Press firmly and evenly on the remote radio switch until each of the switch latches is fully engaged in the mounting hole of the steering wheel rear
trim cover.
3. Connect the steering wheel wire harness connector to the connector receptacle of the remote radio switch.
4. Install the speed control switch (3) or (6) onto the steering wheel See: Cruise Control/Cruise Control Switch/Service and Repair/Speed Control
Switch - Installation.
5. Install the driver side airbag (5) to the steering wheel See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and
Replacement/Driver Air Bag - Installation.
6. Connect the battery negative cable.