Dakota 2WD V8-4.7L Flex Fuel (2009)
1. Position the lower C-pillar trim panel (7) in the vehicle.
2. Route the seat belt, lower anchor, latch plate and turning loop (3) through the slots provided in the lower C-pillar trim panel. Verify that the seat
belt webbing between the retractor and the lower anchor is not twisted.
3. Position the seat belt lower anchor to the mounting hole in the floor panel near the base of the C-pillar and Install the screw (6) that secures the
lower anchor to the floor panel. Tighten the screw to 39 Nm (29 ft. lbs.).
4. Position the lower C-pillar trim panel to the C-pillar (1) and engage the retaining tabs that secure the trim panel to the C-pillar.
5. Install the upper C-pillar trim panel, See: Pillar Trim/C-Pillar Trim Panel-Installation.
6. Install the rear seat, See: Seats/Service and Repair/Seat, Front/Seat - Installation.
7. Install the rear door sill scuff plate, See: Scuff Plate/Service and Repair/Scuff Plate - Installation.
Upper
INSTALLATION
Club Cab, Without Rear Jumper Seats