Dakota 2WD V8-4.7L Flex Fuel (2009)
3. Remove the tire and wheel assembly.
4. Remove the brake line (1) from the brake hose (6) at the frame.
5. Remove the brake hose mounting bolt (3) from the frame.
6. Remove the brake line (1) from the junction block (2) If necessary.
7. Remove the brake hose banjo bolt (4) at the caliper Discard the copper washers (5).
8. Remove the hose (6).
Rear Brake Line - Brake Hose At Axle to Wheel Cylinder
REAR BRAKE LINES - BRAKE HOSE AT AXLE TO WHEEL CYLINDERS
1. Install the line into the bend over tab at axle and then bend over the tab.
2. Install the brake line to the clip on the spring hanger.
NOTE: If brake line (3) was replaced
3. Install the brake line (3) at the brake hose (2) located at the axle.