Dakota 2WD V8-4.7L Flex Fuel (2009)
1. Install the brake hose (6) in position.
2. Install the mounting bracket bolt (3) at the frame, tighten to 14 Nm (125 in.lbs).
3. Install the brake line (1) into the junction block (2) and tighten to 14 Nm (125 in.lbs) If removed.
4. Install the brake line (1) into the brake hose (6) and tighten to 14 Nm (125 in.lbs).
5. Install the brake hose banjo bolt (4) Use new copper washers (5) at the caliper and tighten to 28 Nm (250 in.lbs).
6. Remove the support and lower the vehicle.
7. Remove the prop rod from the brake pedal.
8. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be
performed.See: Brake Bleeding/Service and Repair.