Dakota 2WD V8-4.7L Flex Fuel (2009)
REMOVAL
NOTE: Illustration shown with HVAC housing removed for clarity.
1. Remove the screws (1) that secure the floor distribution duct (2) to the bottom of the HVAC housing (3).
2. Remove the floor distribution duct from the HVAC housing.
Floor Distribution Duct - Installation
INSTALLATION
NOTE: Illustration shown with HVAC housing removed for clarity.
1. Position the floor distribution duct (2) onto the bottom of the HVAC housing (3).
2. Install the screws (1) that secure the floor distribution duct to the HVAC housing. Tighten the screws to 2 Nm (17 in. lbs.).
Instrument Panel Duct - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE: Take the proper precautions to protect the front face of the instrument panel from cosmetic damage during this service procedure.