Dakota 2WD V8-4.7L Flex Fuel (2009)
NOTE: If this flash process is interrupted or aborted, the flash should be restarted.
11. Continue to Section 2SECTION 2 - ADDITIONAL PCM / TCM REPLACEMENT PROCEDURES to complete the process if the ECU has
been replaced.
12. Type the necessary information on the "Authorized Modification Label" (p/n 04275086AB) and attach near the VECI label (See Section 3
SECTION 3 - AUTHORIZED MODIFICATION LABEL for details).
SECTION 2 - ADDITIONAL PCM / TCM REPLACEMENT PROCEDURES
Find the PCM/TCM Type for the vehicle, read and write down the steps, and then go to the step by step instructions for additional information
on how to perform these procedures. STEP-BY-STEP INSTRUCTIONS
If a NGC3 or NGC4 PCM was replaced, perform the following additional steps and/or routines:
1. PCM Replaced - if WCM equipped
2. Learn ETC - if ETC equipped
3. Check PCM Odometer
4. Check PCM VIN - if NOT WCM equipped
5. Quick learn - if EATX equipped
If a GPEC PCM was replaced, perform the following additional steps and/or routines:
1. If the vehicle is equipped with a CVT, ensure that the TCM has the latest software calibration available (if the vehicle is not equipped with a CVT,
skip to Step 3).
2. PCM Replaced - if WCM equipped
3. Learn ETC
4. Check PCM Odometer
5. Check PCM VIN - if NOT WCM equipped
6. TCM Quick learn - if EATX equipped
If a CVT TCM was replaced, perform the following additional steps and/or routines:
1. Initialize CVT
If an EGS TCM was replaced, perform the following additional steps and/or routines:
1. Initialize EGS
STEP-BY-STEP INSTRUCTIONS
Check PCM Odometer
From the "Home" screen, select "ECU View".
-
Select "PCM"
-
Select "Misc. Functions"
-
Select "Check PCM Odometer" and follow the on screen instructions.
-
When complete, select "Finish".
Check PCM VIN
From the "Home" screen, select "ECU View"
-
Select "PCM"
-
Select "Misc. Functions"
-
Select "Check PCM VIN" and follow the on screen instructions.
-
When complete, select "Finish"
Initialize CVT
From the "Home" screen, select "ECU View"
-
Select "TCM"
-
Select "Misc. Functions"
-
Select "Initialize CVT" and follow the on screen instructions.