Dakota 2WD V8-4.7L Flex Fuel (2009)
14. Lift the seat belt webbing (1) up off the top of the belt bracket (3) and weave it through the slot in the front of the belt bezel (2).
15. Position the bezel over the belt bracket with the rear edge tilted toward the back glass.
16. Lower the rear edge of the bezel over the back of the belt bracket far enough to engage the two clips within the bezel with the rear edge of the
bracket.
17. Roll the bezel forward until the front edge is seated against the belt bracket, then press the front downward to engage the two clips within the bezel
with the front edge of the bracket.
Rear Outboard - Club Cab
REAR OUTBOARD - CLUB CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
1. Position the rear seat belt and retractor (1) to the inner C-pillar (3).
2. Engage the tab on the back of the retractor into the T-slot in the inner C-pillar.
3. Install and tighten the screw (2) that secures the retractor to the inner C-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).