Dakota 2WD V8-4.7L VIN P Flex Fuel (2007)
7. If equipped, disconnect the headliner wire harness connector (2) from the inside rear view mirror.
8. If equipped, remove the overhead console.
9. Remove the sun visors (4).
10. Remove the sun visor supports (3).
11. If equipped, remove the front dome lamp.
12. If equipped, remove the rear dome lamp.
13. Remove the two coat hooks.
14. Remove the front seat headrests.
15. Remove the cab back trim panel. Refer to Trim Panel.
16. Remove the rear jumper seat headrests.
17. Remove the rear jumper seat headrest sleeves from the headliner.
18. Lower the rear of the headliner (7) and disconnect the headliner wire harness connector (1) from the center high mounted stop lamp.
19. Recline the front seats.
CAUTION: Be careful not to crease the headliner.
20. Lower the front of the headliner and remove the headliner through the door opening where the seat belt turning loop and height adjuster was
disconnected from the upper roof rail.
Quad Cab
1. Pull the top of each door seal downward slightly.
2. Remove the upper C-pillar trim panels. Refer to Trim Panel.