Dakota 2WD V8-4.7L VIN P Flex Fuel (2007)
Sunroof / Moonroof Frame: Service and Repair
Installation
INSTALLATION
1. Install the trough guides.
2. Install the sight shields.
3. Install the drive motor.
4. Install the sunshade.
5. Install the glass panel.
6. Remove the backing tape from the foam support pad, if necessary.
7. Raise rear end of sunroof module assembly and guide into position and start fasteners.
8. Tighten the fasteners to 9 Nm (80 in. lbs.).
9. Connect the drain tubes.
10. Install the wire harness.
11. Connect battery negative cable.
12. Test sunroof operation, adjust glass as necessary.
13. Partially install the headliner and connect the sunroof wiring electrical connectors.
14. Temporarily install sunroof switch and perform the sunroof motor teach procedure.
15. Complete headliner installation.
16. Verify correct sunroof operation.