Dakota 2WD V8-4.7L VIN P Flex Fuel (2007)
Brake Master Cylinder: Removal and Replacement
Removal
REMOVAL
1. Install the prop rod on the brake pedal to keep pressure on the brake system.
2. Remove the reservoir cap and siphon fluid into a drain container.
3. Disconnect the electrical connector from the fluid level switch in the reservoir (2).
4. Remove the two reservoir mounting screws.
5. Remove the reservoir (2) from the master cylinder.
6. Remove old seals from the cylinder body.
Installation
INSTALLATION
CAUTION: Do not use any type of tool to install the seals. Tools may cut, or tear the seals creating a leak problem after installation. Install the
seals using finger pressure only.
1. Lubricate the new seals with clean brake fluid and Install new seals in cylinder body. Use finger pressure to install and seat seals.
2. Start the reservoir (2) in the seals. Then rock the reservoir back and forth while pressing downward to seat it into the seals.
3. Install the two mounting screws for the reservoir to the master cylinder.
4. Reconnect the electrical connector to the fluid reservoir level switch.
5. Remove the prop rod from the vehicle.
6. Fill and bleed base brake system.
Removal