Dakota 2WD V8-4.7L VIN P Flex Fuel (2007)
8. Carefully disconnect the lever and linkage rod from the blend door pivot lever (4).
9. Disconnect the HVAC wire harness (1) from the blower motor resistor (2), recirculation door actuator (3), and the blower motor (4).
10. Remove the three screws (5) that secure the blower motor to the HVAC housing (6) and remove the blower motor.
11. Remove the HVAC wiring harness from the HVAC housing.
12. Remove the four screws (1) that secure the air inlet housing (2) to the top of the HVAC housing (3) and remove the air inlet housing.
NOTE: If the foam seal on the air inlet housing is deformed or damaged, it must be replaced.
13. If required, disassemble the air inlet housing.