dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Removal and Replacement|Page 7288 > < Removal and Replacement
Page 2
background image

and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or
service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag
deployment.

WARNING:  To avoid serious or fatal injury when removing a deployed airbag, rubber gloves, eye protection, and a long-sleeved shirt should
be worn. There may be deposits on the airbag unit and other interior surfaces. In large doses, these deposits may cause irritation to the skin and
eyes.

WARNING:  To avoid serious or fatal injury, use extreme care to prevent any foreign material from entering the side curtain airbag, or
becoming entrapped between the side curtain airbag cushion and the headliner. Failure to observe this warning could result in occupant
injuries upon airbag deployment.

NOTE:  The following procedure is for replacement of an ineffective or damaged side curtain airbag. If the airbag is ineffective or damaged, but not
deployed, review the recommended procedures for handling non-deployed supplemental restraints. If the side curtain airbag has been deployed, review
the recommended procedures for service after a supplemental restraint deployment before removing the airbag from the vehicle.

1. Check to be certain that the six U-nuts (2) are properly installed in the inner roof rail (1) and that they are in good condition.

Removal and Replacement|Page 7288 > < Removal and Replacement