Dakota 2WD V8-4.7L VIN P Flex Fuel (2007)
8. Remove the screw (2) that secures the retractor (1) to the inner C-pillar (3).
9. Lift the retractor upward far enough to disengage the tab on the back of the retractor from the T-slot in the inner C-pillar.
10. Remove the rear seat belt and retractor from the vehicle as a unit.
Rear Outboard - Quad Cab
REAR OUTBOARD - QUAD CAB
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Unsnap the upper edge of the trim cover (5) from the rear outboard seat belt turning loop (4) and disengage the tab on the lower edge of the cover
to access the turning loop screw.
2. Remove the screw (6) that secures the seat belt turning loop to the upper C-pillar (1).
3. Remove the seat belt turning loop from the C-pillar.
4. Remove the upper trim (2) from the inside of the C-pillar.