Dakota 2WD V8-4.7L VIN P Flex Fuel (2007)
Preparation Before Backlite Installation
1. Manually remove as much urethane adhesive as possible from around the fence opening. For any remaining urethane that exhibits a cohesive
failure at the fence, trim the remaining urethane bead (1) to a 1 to 2 mm thick layer. Bonding of the new urethane will be directly onto this 1 to 2
mm thick layer on the fence.
2. The fence must be cleaned with a new 100% alcohol wipe.
3. Apply a solid or even black layer of primer (1) to the fence (2) and allow to dry for 5 minutes.
04 BEAD DIMENSIONS
NOTE: The backlight must be installed within 5 minutes of applying the urethane bead.
4. Clean urethane adhesive from around backlite opening fence.