Dakota 2WD V8-5.9L VIN Z LDC (2000)
Multi-Function Switch Connector
5. Move the upper fixed column shroud far enough to access the rear of the multi-function switch.
6. Remove the tamper proof mounting screws (a Snap-On tamper proof torx bit TTXR20B2 or equivalent is required that secure the multi-function
switch to the steering column.
7. Gently pull the switch away from the steering column far enough to access and remove the multi-function switch wire harness connector screw.
8. Unplug the wire harness connector from the multi-function switch.
9. Reverse the removal procedures to install. Tighten the fasteners as follows:
-
Multifunction switch wire harness connector screw - 2 Nm (17 in. lbs.).
-
Multi-function switch mounting screws - 2 Nm (17 in. lbs.).