Dakota 4WD V6-3.7L (2008)
Rear Door Hinge: Service and Repair
Door - Rear (Quad Cab)
Removal
REMOVAL
NOTE: It is not necessary to remove the door to replace the hinges if they are replaced one at a time.
NOTE: A suitable body sealant should be used when removing or moving the hinges.
1. Open the front door.
2. Remove the lower b-pillar trim (4), See: Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar Trim/B-Pillar Trim.
3. Using a grease pencil or equivalent, mark the location of the door hinges on the door.
NOTE: The epoxy bonded washers do not need to be separated from the hinges. If the washers are removed, the door may need to be
re-adjusted.
4. Support the door with a suitable lifting device and remove the two nuts (2) and two bolts (1) that secure the door to the hinges.