Dakota 4WD V6-3.7L (2008)
Fluid - A/T: Service and Repair
Fluid Level Check - 42RLE
FLUID LEVEL CHECK
The transmission sump has a dipstick to check oil similar to most automatic transmissions. It is located on the left side of the engine. Be sure to wipe all
dirt from dipstick handle before removing.
The torque converter fills in both the PARK and NEUTRAL positions. Place the selector lever in PARK to be sure that the fluid level check is accurate.
The engine should be running at idle speed for at least one minute, with the vehicle on level ground. At normal operating temperature
(approximately 82° C or 180° F), the fluid level is correct if it is in the HOT region (cross-hatched area) on the oil level indicator. The fluid level should
be in COLD region at 21° C (70° F) fluid temperature. Adjust fluid level as necessary. Use only Mopar(R) ATF+4, Automatic Transmission Fluid.
FILL TUBE EQUIPPED WITH INDICATOR
42RLE Fluid Fill
42RLE Fluid Temperature Chart
NOTE: Engine and Transmission should be at normal operating temperature before performing this procedure.
1. Start engine and apply parking brake.
2. Connect scan tool and select transmission.
3. Select sensors.
4. Read the transmission temperature value.
5. Compare the fluid temperature value with the chart.
6. Adjust transmission fluid level shown on the dipstick according to the 42RLE Fluid Temperature Chart (shown). Use only Mopar(R) ATF+4,
Automatic Transmission Fluid.
7. Check transmission for leaks.
CAPPED FILL TUBE
1. Verify that the vehicle is parked on a level surface.
2. Remove the dipstick tube cap.
WARNING: There is a risk of accident from vehicle starting off by itself when engine running. There is a risk of injury from contusions
and burns if you insert your hands into the engine when it is started or when it is running. Secure vehicle to prevent it from moving off by
itself. Wear properly fastened and close-fitting work clothes. Do not touch hot or rotating parts.
3. Actuate the service brake. Start engine and let it run at idle speed in selector lever position "P".
4. Shift through the transmission modes several times with the vehicle stationary and the engine idling
5. Warm up the transmission, wait at least 2 minutes and check the oil level with the engine running. Push the Oil Dipstick 9336 into transmission fill
tube until the dipstick tip contacts the oil pan and pull out again, read off oil level, repeat if necessary.
NOTE: The dipstick will protrude from the fill tube when installed.
