Dakota 4WD V6-3.7L (2008)
INSTALLATION
1. Slide new boot down the half shaft.
2. Install tripod (1) and tripod snap ring on the half shaft.
3. Pack grease supplied with the joint/boot into the housing and boot.
4. Coat tripod with supplied grease.
5. Install new bushing (1) onto the housing (2).
6. Insert tripod and shaft in the housing.
7. Position boot (2) on the joint in its original position.
NOTE: Verify boot is not twisted and remove any excess air.
8. Secure both boot clamps with Clamp Installer C-4975A. Place tool on clamp bridge and tighten tool until the jaws of the tool are closed.
