Dakota 4WD V6-3.7L (2008)
1. Manually remove as much urethane adhesive as possible from around the fence opening. For any remaining urethane that exhibits a cohesive
failure at the fence, trim the remaining urethane bead (1) to a 1 to 2 mm thick layer. Bonding of the new urethane will be directly onto this 1 to 2
mm thick layer on the fence.
2. The fence must be cleaned with a new 100% alcohol wipe.
3. Apply a solid or even black layer of primer (1) to the fence (2) and allow to dry for 5 minutes.
04 BEAD DIMENSIONS
NOTE: The backlight must be installed within 5 minutes of applying the urethane bead.
4. Clean urethane adhesive from around backlite opening fence.
5. If necessary, apply black-out primer to outer edge of replacement backlite frame (1).
6. If black-out primer was pre-applied on backlite, clean bonding surface with Isopropyl alcohol and clean lint free cloth. Allow 5 minutes for drying
time.
7. Apply black-out primer to backlite opening fence.
8. Apply a 13 mm (0.5 in.) (2) X 9.5 mm (0.375 in) (1) bead of urethane around the perimeter of the window frame bonding surface.
CAUTION: Bead location, close to the metal edge, is critical to avoid urethane "squeeze out."