Dakota 4WD V6-3.9L VIN X (1997)
Lock Cylinder Switch: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the door trim panel and the door outside latch handle.
Door Lock Cylinder Switch Remove/Install - Typical
3. Pull the door outside latch handle out from the outside of the door far enough to access the door lock cylinder switch.
4. Unplug the door lock cylinder switch from the back of the lock cylinder.
5. Unplug the door lock cylinder switch wire harness connector.
6. Disengage the two retainers that secure the door lock cylinder switch wire harness to the door inner panel.
7. Remove the door lock cylinder switch from the door.
8. Reverse the removal procedures to install.
