Dakota 4WD V6-3.9L VIN X (1997)
4.
Install the two (2) lower license plate bracket screws. These screws MUST be installed on an approximately 27 degree angle from horizontal with
the washer head of the screw fully seated against the angled surface of the license plate bracket for proper installation (Figure 1).
NOTE:
THE LENGTH OF THE TWO LOWER ATTACHING SCREWS WILL BE TOO SHORT IF THEY ARE INSTALLED HORIZONTALLY.
INSTALLING LONGER SCREWS WILL ONLY RESULT IN AN IMPROPER AND DISTORTED FIT OF THE FRONT LICENSE PLATE
BRACKET TO THE FRONT BUMPER FASCIA.
5.
Attach the license plate to the front license plate bracket.
POLICY: Information Only